Next Day Delivery Available 
Local Delivery Included*
Extensive Show Garden
Ethically Sourced
A-JOINT TRAFFIC RESIN PAVING GROUT
A-JOINT® TRAFFIC is a heavy-duty paving grout specially developed for public areas. It is designed for traffic loads of up to 40 t, is sweeper-suction machine resistant and at the same time frost and de-icing salt resistant.
Due to its high flowability and self-compacting properties, A-JOINT® TRAFFIC can be used for joints as small as 5 mm. Due to its fast curing, the grouted surface can be walked on after only 6 hours and driven on after 24 hours. A-JOINT® TRAFFIC can be used universally for everything from new jointing to the renovation of existing surfaces, reducing maintenance costs and the risk of accidents caused by loose stones.
A-JOINT® TRAFFIC is particularly suitable for highly frequented squares, public roads and paths as well as for use in paved street gutters.
Why Choose A-JOINT® TRAFFIC
German Precision, Built for the UK Climate
Processing instructions:
Preparing the site
The joints must be cleaned of weeds, roots and loose parts and cleared to a depth of at least 30 mm or, in case of traffic load, to 2/3 of the stone height. The surface to be grouted must be free from all dirt. Adjacent areas that are not to be grouted should be masked or covered. To avoid settling and loose stones, we recommend a permanently water-permeable and load-bearing substrate corresponding to the subsequent load (pay attention to the current standards and guidelines). We generally recommend the bonded construction method.
Pre-wetting
Pre-wet the entire surface extensively. Higher soil temperatures and absorbent, open-pored stone require more intensive pre-wetting. Generally, use clean and cold water.
Mixing
Open the bag and pour the sand into a suitable mixing container. Add the contents of the separately supplied bottle containers completely. Fill and cap the emptied bottles with 0.5 litres of water each, shake vigorously and add to the mixture. Make sure that the bottles are completely empty. Use a professional stirring or mixing device. Start the mixing process. After 3 minutes mixing time, add another 2.0 litres of water and mix thoroughly for another 3 minutes until a creamy, flowing mass is obtained.
Filling the joints
Pour the finished mixture onto the well pre-wetted surface. Carefully work in the joint compound with a rubber squeegee, as diagonally as possible to the joint. Keep the surface constantly wet during this work.
Cleaning the surface
After approx. 10-20 minutes, sweep the stone surface carefully and diagonally to the joint, using a medium-coarse street broom. If white gel-like streaks form on the stone surface, the correct sweeping time has not yet been reached. Then remove the remaining mortar residues with a fine coir broom. Swept-off material is not to be used again. Make sure that chamfers (beveling of the side edges) on slabs and pavers must be exposed.
with a choice of three different colours to suit every job.
neutral
stone grey
basalt
Basket
Account
01909 772 302